4 - 6 mm
Throttle lever free play
Outer tube
Hex screws
Handle
Moutning
plate
Throttle assembly
Adjusting the handle
4 - 6
mm
Cable
adjuster
Lock nut
Rotate the cable adjuster as required to
obtain correct free play
/RRVHQWKHIDVWHQHUVRQWKHDLU¿OWHUFRYHU
Adjusting throttle lever free play
5
Assembly and adjustments
Prior to assembly
This Shindaiwa Multipurpose Tool Carrier
comes fully assembled. You only need
attach the accessory tool of your choice to
the powerhead. Your Multipurpose tool
carrier includes:
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Throttle lever free play
The throttle lever free play should be
approximately 4 - 6 mm. Make sure that
the throttle lever operates smoothly
without binding. If it becomes necessary to
adjust the lever free play, follow the proce-
dures and illustrations that follow.
Loosen the air cleaner cover knobs and
1.
remove the air cleaner cover.
Loosen the lock nut on the cable
2.
adjuster.
Turn the cable adjuster in or out as
3.
required to obtain proper free play 4-6
mm (3/16-1/4 inch).
Tighten the locknut.
4.
Reinstall the air cleaner cover.
5.
This owner/operators’s manual
Ŷ
Tool kit for routine maintenance. Tool
Ŷ
kits vary by model and may include a
hex wrench, and a spark plug/screw-
driver combination wrench.
Handle
Your Shindaiwa Multi-Purpose Tool Car-
rier comes with the handle installed. It can
be re-adjusted for operator comfort in the
following manner.
Loosen the four hex screws..
1.
Rotate/slide handle assembly to best
2.
position for operator comfort, usually
25 cm (10 in.) ahead of the throttle
assembly.
Tighten hex screws in a crisscross
3.
manner.
Summary of Contents for M2510/EVC
Page 19: ...21 NOTES NOTAs REMARQUES...
Page 39: ...SP_21 Espa ol NOTES NOTAs REMARQUES...
