When the two tube halves are locked together, press down on the spring-loaded latch protector
Press latch
Tool assembly
Lower tube assembly
Coupler
Latch
Coupler screw
knob
Locking hole
Latch protector (extended)
Latch Protector (lowered)
Coupler Screw Knob
Coupler
Insert the tool assembly into the coupler
6
With the unit on a clean, flat surface,
1.
loosen the coupler screw. The spring-
loaded coupler protector should pop up.
Press down on the latch with your finger
2.
or thumb. This releases the coupler lock.
Pull the upper tube assembly out of the
3.
coupler.
Disassembling the tube sections
Slip off the protective plastic cover(s)
2.
from the ends of the tube(s), and
loosen the coupler screw knob.
Insert the tool assembly into the cou-
3.
pler, with the tool decal facing up, until
the line of the decal is flush with the
end of the coupler.
Twist the tool assembly back and forth
4.
until you are sure it snaps in place by
the coupler latch.
When the two tube halves are locked
5.
together, press down on the spring-
loaded latch protector and tighten the
coupler screw knob.
Assembling tube sections
Place powerhead/lower tube assembly
1.
on a clean, flat surface so that both
assemblies fit end to end. The power-
head/lower tube assembly should be
facing positioned with the locking hole
in the tube end facing up.
CAUTION!
Keep the open ends of the tubes clean
and free of debris!
3UHVVGRZQRQWKHODWFKZLWK\RXU¿QJHURUWKXPE
Assembly and adjustments
(continued)
CAUTION!
Verify that there is no gap between the
latch protector and coupler.
Summary of Contents for M2510/EVC
Page 19: ...21 NOTES NOTAs REMARQUES...
Page 39: ...SP_21 Espa ol NOTES NOTAs REMARQUES...
