We declare under our sole responsibility that the
product described under “Technical Data” conforms to
the following standards or normative documents:
EN 60335-1, EN 60335-2-29, EN 55014-1,
EN 55014-2, EN 61000-3-2, EN 61000-3-3,
2014/35/EU, 2014/30/EC
Zhang Yong
General Manager
Jan 1st,2020
Yongkang Meiloy-K&FP Tools Co.,Ltd.
No.218 Meilong Rd., Yongkang, Zhejiang, China
www.ShineMate.com
.
The manufacturer and his representative are not liable
for any damage and lost profit due to interruption in
business caused by the product or by an unusable
product.
The manufacturer and his representative are not liable
for any damage which was caused by improper use of
the power tool or by use of the power tool with
products from other manufacturers.
STORAGE AND MAINTENANCE
▶
New battery pack need to be charged before use.
▶
Remove the battery pack from the tool for charging
when convenient for you and your job. SHINEMATE
batteries do not develop a "memory" when charged
after only a partial discharge. It is not necessary to
run down the battery pack before placing it on the
charger.
▶
The battery packs not in often use need to be
charged for each 3 months.
▶
The long-time uncharged battery pack may enter
into a "sleep" status due to the gradually dropping
down of voltage, charger may not be able to reactivate
it. Such battery pack needs to be sent to the service
center to reactivate with special equipment. The
reactivation is not guaranteed to be successful
subject to battery condition.
▶
Align the battery pack with the bay and slide the
battery pack into the charger until it is locked.
▶
The red light may come on, either continuous
(battery pack is too hot or cold), or flashing (battery
pack is faulty).
▶
The green light will come on, flashing quickly(pack
is charging)
▶
The green light come to flashing slowly(charging is
approaching full), this pack is 80% full, it can use
now, but it is suggested to continue the charging until
it is fully charged.
▶
When charging starts at any of the bays, the
corresponding cooling fan starts to run.
▶
After charging is complete, the green light will
come continuous on.
▶
Use the level indicate button on the battery pack to
show the how fully charged the pack is.
▶
The charger will keep the battery pack fully
charged if it is left on the charger.
▶
The charger will charge the 2 battery packs in
turns, the first pack been inserted in will be charged
firstly, the green light near the 2nd pack flashing very
slowly (battery pack is waiting for another pack to
finish charging)
▶
Mounting to the Wall: Use the wall mount guides to
mark the hanging points.
WHEN TO CHARGE THE BATTERY PACK
HOW TO CHARGE THE BATTERY PACK
EXEMPTION FROM LIABILITY
CE-DECLARATION OF CONFORMITY
▶
Store your charger in a cool, dry place.
▶
Unplug battery chargers and remove batteries when not
in use.
WARNING
To reduce the risk of injury, always unplug the
charger and remove the battery from the charger
before performing any maintenance.
Never disassemble the battery or charger. Contact
a SHINEMATE service facility for ALL repairs.
▶
Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
▶
Remove dirt and dust from the housing with a paint
brush or dry cloth, keeping away from all electrical
contacts.
▶
Never use flammable or combustible solvents around
batteries, charger, or tools.
▶
Never immerse your battery or charger in liquid or allow
a liquid to flow inside them.
Level Indicator
Button
