49(60)
4.
Operation Guide
4.1 Startup Pretest
Unpainted part of the machine has been covered with stainless oil. Before use, the
stainless oil should be cleaned.
1) Clean with a towel.
2) Wash with a towel dipping with amyl acetate.
4.1.1 Before the First Startup
1) Check whether the granulator is in the level state.
2) Check the space of the cutting tools to see whether the lockup screws of
the blades are tightened.
3) Before granulating, make sure the main shaft of the granulator is in right
rotating direction.
Caution!
Adjust the machine to make its four holders to share the weight and be in
a level state.
4.1.2 After First Startup for 2 Hours
1) Check whether the lockup screws of the blades are loose.
2) Check the position-adjusting screws of the motor and check whether the
position-adjusting screws are tightened.
4.1.3 After First Startup for 20~30 Hours
Check and adjust the belt's tensility after a 20~30-hour full-load operation.
4.2 Circuit Connection
The installation of the granulator's circuit must be conducted by the
professional electricians.
1) Connect granulator to the power.
2) Connect the transmission belt clockwise.
Summary of Contents for Budget SG-24EB Series
