44(51)
9) Install both the transmission belt (Fig. 13) and belt tension regulator (Fig.
14).
10) Install micro-switch and fixed board firmly (Fig. 10).
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Picture 6-3: Installation of The Rotor
6.3.3 Honeycomb Rotor Cleaning Steps
1.Use a vacuum-cleaner with brush to suck up the dust on rotor surface.
2.Blow off the dust in the rotor channels with compressed air.
3.If there is dirt sticking to the channel walls inside the rotor, cleaning steps are as
follows:
a. Saturate the rotor by blowing humid air (higher than 60%RH) through the
rotor without having regeneration circuit on. This can be done by just turning
the regeneration heater off and still have the process blower running if
process air has high humidity. If the process air is too dry try to put a
humidifier in the air stream. Do this for one hour.
b. According to the character of the dirt, sink the rotor into water with cleaning
agent in it (PH value 3~2 liquid is applied to silica gel, PH value 7~10 applied
