60(77)
Attention!
Sharp blades may cause personal injuries.
4.3.1 Open Screen Frame
1) Turn off shredder power.
2) Unscrew fixed bolt at two sides of frame then pull it out.
3) For replacing screen, user needs to dismantle the whole frame firstly.
Attention!
Screen frame is supported by pneumatic spring bar so it would not drop
down when opening. Use an object to support frame if manually working
under screen to prevent injuries caused by spring bar failure.
4.4 Close Screen Frame
Attention!
Hold the handles on frame tightly and push them toward crushing
chamber to close frame, then lock fixed screws at two ends of screen.
Take care!
Avoid crushing injuries when close frame!
4.4.1 Install Screen Frame
1) Put screen into frame, match hole sites and fix them via lockup bolts.
2) Refer to installation instruction for details.
Picture 4-1: Installation of Screen Frame and Storage Hopper
Summary of Contents for SGS-6080S
