10(49)
1.4 Emergency Stop
The emergency stop button is located on the hand controller.
When the emergency stop button is pressed, the power is turned off. The gripper and
vacuum valves and the vacuum generator are not disconnected in order to avoid dropping
parts from the gripper. In addition, the control system and the hand controller will remain
under power to allow indication of error messages.
The emergency stop circuits of the robot and of the injection molding machine are connected
by the Euromap12 and Euromap67 interface. Therefore when the emergency stop button on
the molding machine is pressed the robot will also stop and vice versa.
Any problem during using Shini robots, please contact our company or the local vendor.
Headquarters & Taipei Factory: TEL
：
(02)26809119
China Service Hotline: TEL
：
800-999-3222
Dongguan Factory: TEL
：
(0769)83313588
Ningbo factory: TEL
：
(0574)86719088
1.5 Transportation and Storage
Prohibit persons underneath the robot during transportation.
If there is compelling reason for moving or re-installing the robot, please enquire for
assistance from the manufacturer or agents. If you do not comply with this mandatory
requirement, result in the injury to any personnel and equipment, the robot
manufacturer will not have any responsibility.
1.5.1 Transportation
1. The series robot before sending out package in crates, and at the bottom of the crate with
gap left, convenient to use forklift to move.
2. Before the transporting, lock the arm anti-falling bolter, prevent arm out during
transportation.
3. The arm may swing, before transporting, turn the shock absorber on rotation cylinder to
the limiting position, and fixed the arm, prevent damage to the arm.
4. During the transporting, prevent collision to damage the robot.
5. In the long-distance transport, should increase plastic bag, and if necessary vacuum
pumping and put desiccant in.
6. The temperature between -25
to 55
during the transportation, for short transportation
℃
℃
(in 24 hours), the temperature cannot higher than 70
.
℃
The robot you order before sending out the factory, it is confirmed in good working condition,
please check whether there is any damage during carrying or transporting. Please be
carefully, when dismantling of components and packaging, if the robot has found the injury,
you can use the package again.
