14(49)
2.1.5 Mounting Preparation
Picture 2-1: Driling Sticker
1. Before drilling, switch off the IMM then turn off the power supply in order to prevent any
damage to the mold.
2. Put the drilling sticker (as the picture) on the installing surface of IMM.
3. Use the center punch to fix the positions.
4. Place electrical drill with magnet base on the fixing plate, use 8.5 drill bits to drill 6 holes
about 30mm depth.
5. Use M10 tap to produce 6 internal screw threads about 25mm depth.
2.1.6 Mounting Instruction
1. Avoid sharp pounding; collision and falling when transfer the robot to the top of IMM.
2. Adjust the torque spanner to 77Nm after the robot has been fixed on the right position;
tighten the M10
×
30 hex socket bolt screws.
2.2 Dimensions (Unit: mm)
Picture 2-2: SS-S1 Dimensions