7(49)
1. Safety
Before starting up the robot for the first time, please review this manual thoroughly
and familiarize yourself with the operation of the robot. Improper use may injure
personnel and/or damage the robot, mold or molding machine.
1.1 Safety Regulations
●
Please review this manual thoroughly and familiarize yourself with the operation of the
robot, before starting up the robot for the first time. Maintenance should be performed by
qualified personnel only.
●
The SS-S series robot is designed for injection molding machine (IMM) ONLY.
●
Any modification or change to the original design of the robot is forbidden.
●
Any improper installation and operation may result in injury to personnel and/or damage
to equipments.
●
Please contact the manufacturer or local vender immediately if there is any problem with
robot when operate it.
●
Please note that our robot must be cooperated with other safety device (i.e. safety door)
in order to operate in normal condition.
●
Ensure all installations are met with safety requirements before operating.
●
Without the written consent of the manufacturer, any damage or lost caused by the
modification or use beyond the user manual, the manufacturer will not have any
responsibility.
1.2 Safety Concerns
●
The maintenance, repair, etc, must be executed by professionally trained personnel.
●
Any unrelated personnel should keep away from robot working area while it is operating.
All electrical wiring must be completed by professionals.
●
Please use safety fence indicate working area while robot installation.
●
For the safety operation, the hand controller should be placed outside the robot working
area.
●
Ensure bolts and nuts are tightened with torque wrench while installation.
●
Ensure there are no following matters in the compressive air: phosphate-containing oil,
organic solvents, sulfite gas, chlorine, acids and stale compressor oil.
●
The air pressure should be kept at 6MPa
±
0.1MPa while operation.
●
Remove anything from the top of the robot to prevent falling due to vibration.
●
Press EMERGENCY STOP button immediately when accident occurs.
●
Do not modify the robot body and control box. Please contact manufacturer or vendor if
any change is required.
●
Turn off power supply and compressed air before maintenance and adjustment. Also set
up warming signs and safety fences.
●
Please use parts of SHINI if there is any replacement is required.
●
Our robots meet all corresponding safety standards.
●
Please read the user manual carefully as a safety guideline.