EinScan HX User Manual
69
Click
Close
to confirm the movement and exit the movement interface.
Figure 3-58 Movement
3-2-1 System Movement
3-2-1 system movement aligns data by selecting the point, line and plane. Before movement, create
feature points, lines and planes. The feature lines created are not perpendicular to the plane.
Create features before using the 3-2-1 system movement. For details, see
The coordinate system on the interface represents the global coordinate system. Red=X+, Green=Y+,
Blue=Z+.
1. Make a one-to-one correspondence between the created feature points, lines and planes with the
origin and axis of the coordinate system to be aligned. That is, the normal of the selected plane
corresponds to the coordinate axis; the selected feature point corresponds to the origin.
Select a feature surface in the plane drop-down menu, and select an axis in the corresponding
constraint drop-down menu of the plane. The arrow on the plane corner indicates the positive
direction of the plane, and the selected axis direction will be consistent with the plane direction.
Select a feature line in the drop-down menu of the line, and select an axis in the drop-down
menu of the line. The arrow of the line indicates the positive direction of the line, and the
direction of the selected axis will be consistent with the direction of the projection of the line on
the selected plane.
Click the drop-down menu to select a point, the position of this point is the origin of the
coordinates (0, 0, 0).
Summary of Contents for EinScan HX
