SHINING 3D - EinScan-Pro series - User Manual - June 2019
38
●
moving or vibrating objects, which cause the shape of object changed during
scanning process.
●
lattice structures with many small deep holes
During scanning the shape of the object needs to be maintained without any changes
(human bodies must be held still, for example).
Example of an object, difficult to scan
4.2.
Preparation
To align data if geometry features are not sufficient, you need to stick markers or
pieces of clay on the surface of scanned objects to create extra “features”.
When you stick markers on the surface of the object, you need to follow the
following rules:
(1)
Make sure sticking at least 4 markers in each frame (one scanning field of view).
Control the number of markers seen on the camera view.
(2)
Stick markers in a random, non-linear pattern (see example below).
(3)
Markers should be stuck on the flat surface area and keep the marker surface
flat.
(4)
Use the markers provided with the device only. Other markers can result bad
accuracy or not to be seen.
The pure black letters are
hard to be captured by
the scanner.
The silver bottom is highly
reflective, so it also hard
to be seen by the scanner.
The can is
symmetrical and
has no geometry
features on the
surface. It is
difficult for the
software to align
the scanned data.
Summary of Contents for EinScan Pro
Page 17: ...SHINING 3D EinScan Pro series User Manual June 2019 17 EXScan Pro on the start menu ...
Page 30: ...SHINING 3D EinScan Pro series User Manual June 2019 30 Add on is required for this function ...
Page 41: ...SHINING 3D EinScan Pro series User Manual June 2019 41 4 4 Scan Workflow ...
Page 52: ...SHINING 3D EinScan Pro series User Manual June 2019 52 Browse to load a GMF ...
