FreeScan UE Pro_ User Manual _V1.2.2 37
Manual hole filling
Click the edge of the hole to fill it.
Click
, according to the order of filling holes, from the last hole to cancel hole filling. Ctrl + Z can also
cancel hole filling.
Click
Confirm
to apply current setting and exit the manual hole filling.
Click
Cancel
to quit and go back to the original data.
3.5.6 Cutting Plane Tool
Readjust the front direction of the scanned data if the data is not aligned or the front direction needs to be
redefined.
Steps
1.
Hold down the
Shift+ LMB
and drag the cursor to draw a straight line.
2.
Click
Intersect Plane
to
create a plane. The front is above the plane. The scanned data in the reverse
direction of the plane is displayed in red (the data to be deleted)
3.
Select the area to be deleted.
⚫
Reverse Selection: After clicking
Reverse Selection
, the scanned data in the forward direction of the
plane is in red.
⚫
Delete the selection and close the intersection: Delete the selection and close the intersection: delete the
red area and fill in the scan data that coincides with the created plane.
⚫
Delete selection: Delete the red area.
4.
Click
Apply
to delete the red area.
5.
Click
Orient Based On Plane
, the scanning model will be readjusted according to the direction of the plane
arrow.
6.
Click
Confirm
to save the edit and close the Cutting plane tool window.
3.6 Measurement
After Meshing, the software can switch to the measurement interface, or directly enter the measurement
interface to import data, and perform operations such as measurement and alignment on the data.
The measurement interface and the post-processing interface share the same data.
On the operation progress bar, click
to enter the measurement interface.
Click
to select the file to be measured; or directly drag the file in STL, OBJ, PLY format to the
measurement interface.
