Shining Technology CitiDISK HDV Quick Usage Guide v8.0 Shining Technology CitiDISK HDV Quick Usage Guide v8.0
7). Click on the
“Upload / Upgrade Device Firmware
” button.
Follow the instructions and the system will ask for the firmware
target. Select the one you just download (must be in a binary
form).
Select the file named like “FW1256HC-oxfw911-10062005” as the
example shown above with the “Binary” or “bin” file extension.
Click on “Open” and then “OK” to continue. This process will take
approximately 10 seconds to write the new firmware into the unit.
Once the upload process is completed, the CitiDISK HDV will re-
synchronize itself to the system and both
RED
&
GREEN
lights will
blink alternately.
Turning On Internal Battery Before Usage
Charging the Internal Rechargeable Battery
Powering On/Off the CitiDISK HDV
Power on
:
Toggle the “PWR” button (closest to
the external power adapter input)
once. When the internal battery has
less than 5 minutes of power
remaining, this power status light will
start to blink and will stop recording
before shutting off the unit
completely.
Power off
:
Toggle the
GREEN “PWR”
button
again.
Turning on the battery
:
Use a sharp pencil tip to slide the switch left
to the “white dot” position. Without doing
so the CitiDISK HDV will not operate.
Turning off the battery
:
Use a sharp pencil tip to slide the switch to
the right position while in storage or in
transit so as not to drain the battery when
it’s not in use.
Charging power is drawn from the FireWire
bus power or external power adapter. A
minimum of 4 to 6 hours of charging time
is required before use.
The
BLUE
LED
indicates battery charging is
in progress. Once the battery is fully
charged, the
BLUE
LED will turn off.
P12
P5
