12
5.3 Mounting to DIN rail
Notice
•
Mount the DIN rail laterally.
•
The following shows DIN rail corresponding to the NCL-13A.
Width :
35mm
Height
: 7.5mm or more
Groove width : 23mm or more
DIN rail mounting screw height:
3.4mm or less (At a DIN rail height
of
7.5mm)
(Fig. 5.3-1)
•
If the DIN rail is mounted in a position susceptible to vibration or shock, be sure to
use End plates (AEP-001-1, sold separately) at both ends of the unit.
•
Do not confuse the top and bottom of this unit.
•
When mounting to or removing the unit from the DIN rail, the units must be slanted
a little.
Therefore do not mount any other instruments within 50mm of space at the left side,
upside and down side from the unit, considering radiation.
(Fig. 5.3-2)
50mm or more
50mm or more
50mm or more
