SPRW_ENGLISH _101
15
Safety Features
▽
Misfiring Detector
Prevents gas being discharged when the burner is not lit.
▼
When fire goes out for any reasons, this devise detects it and shuts off the supply of gas to the Burner,
preventing gas being discharged into the air.
▽
Overheating Detector
When the appliance overheats, this device shuts off the supply of gas and Sounds an alarm.
▼
Possible causes for overheating include:
1. Water is not present in the Drain Pan.
2. Parts are soiled with grease and burner flames are being sucked into the exhaust duct.
3. Exhaust Fan is not operating properly.
4. The exhaust air volume is low due to filter clogging, etc.
5. Clogged Burner Holes force gas to flow backward and burn at the Gas intake.
▼
You may resume the operation of the appliance after it has cooled down (5 to 10 minutes) and the alarm
sound has stopped. The alarm will stop automatically when the appliance cools down.
※
Allow the appliance to cool down before you attempt to service the appliance
.
Shutting Alarm Off
You may stop the alarm manually by turning off the Alarm Switch located next to the Burner Control Knob.
The supply of gas however, however, will not be resumed until the appliance cools down to an acceptable
level.
Make sure to turn the Alarm Switch on again when normal operating conditions are restored (all the causes
for overheating have been removed and the appliance has cooled down to an acceptable level).
The Alarm Switch should be turned on during normal operation. If it is turned off, warning beep will not
sound and undetected overheating may result in a risk of fire.
Make sure the appliance has cooled down to a safe level when you inspect the appliances.
Table Top
Alarm Shutoff Switch
Lamp
Slim Control
Summary of Contents for SPRW
Page 18: ...Memo ...
Page 19: ...Memo ...
