1. DC POWER INLET:
The switcher is fitted with a AC power plug
input connector. Ensure that the plug used is of an approved type
and is of sufficient current carrying connector capacity with the
correct voltage and connector polarity. 100~240Volt AC, 50/60Hz
power supply.
2. IR EXTENDER CONTROL:
Supports (1) IR extender. Extends
maximum distance of ~984 ft/300M. When you plug the external
IR extender into the switcher, the front panel IR receiver remains
active.
3. RS-232 CONNECTION:
RS-232 control port allows for interfacing
to a PC, such as a computer or touch panel control, to the switcher
via the DB-9pin female connector for serial RS-232 control.
4. ETHERNET CONNECTION:
ETHERNET control port allows for
TCP/IP interfacing to a PC, such as a computer or touch panel
control (not a web-browser), to the switcher via the RJ-45 female
connector to control switcher.
POWER SOCKET:
Connector Type : IEC 60320 C13
IR EXTENDER JACK:
Female Jack - inner OD Ø 3.5mm
REMOTE PORT:
D-SUB-9pin female connector
REMOTE PORT:
Control the switcher RJ-45 female
connector
Ethernet Port:
Note: The Ethernet port and RS-232 port cannot
be used simultaneously. Any connection to the
Ethernet port will disable serial commands sent
to the RS-232 port.
8
BACK PANEL-SWITCH CONTROLS
BACK PANEL-SWITCH CONTROLS