Shisha-Turbine
®
Turbo
Take off - Manual:
1. Plug in the power cord.
2. Wait until the heating spiral glows.
3. Place the charcoals on the heating spiral (max. 10 pcs.).
4. Turn the charcoals around after 2-3 minutes.
5. Take the charcoals out after approximately 2 minutes.
(Don’t leave charcoals lying on the heating spiral!)
6. Remove the power plug.
7. Let the Shisha-Turbine
®
Turbo cool down.
Maintenance Note:
We recommend to clean the heating spiral of your Shisha-Turbine
®
after every 5th
usage with a wire brush and compatible oil. The best way to handle this is with our
Protect&Care Set, which lets you follow these steps:
1. You unplug your Shisha-Turbine
®
from the power supply.
2. Roughly remove residues from the heating spiral with our Cleansing Brush.
3. Take a paper towel, give a few drops of our Protect&Care Oil on it and remove
the residues from the heating spiral.
4. Use another paper towel and wipe the spiral clean.
5. If consistent residues still appear, repeat steps 3 and 4 until you no longer
detect residues.
6. Finally plug in your Shisha-Turbine
®
and let it run without charcoals, until the oil
residues are burned.
After that you can light up your charcoals as usual.
