11
FAILT CODES, REMEDIAL MEASURES
Code
Solution
Full water Indicator illuminates and beeps.
The water in the base plate of the unit reaches the fill I water level,
drain the water in the base plate refer to drainage section.
Е1
The refrigerant / thermostat / sensor has an anomalous reading, ensure
adequate ventilation around machine, wait 30 minutes and restart. If
fault code persists, this may be due to equipment malfunction, please
contact customer service.
Е2
The room thermostat / sensor has an anomalous reading, ensure
adequate ventilation around machine, wait 30 minutes and restart. If
fault code persists, this may be due to equipment malfunction, please
contact customer service.
Е3
The cooling system is not functioning at normal efficiency. The most
likely cause is an exhaust restriction, kink, or obstruction. Shutdown
and fully inspect appliance, inspect exhaust duct (refer to assembly
instructions). Otherwise, this may be due to equipment malfunction, or
refrigerant leakage, please contact customer service.
Е4
The condenser requires defrosting, the unit will stop working for a
several minutes to Auto-Defrost; then will resume operation as normal.
Important note: The unit complies with relevant safety and performance standards. An electrical specialist must
carry out repairs.
