7
WATER DRAINAGE
This product has a self-evaporating system.
The condensing water will be recycled to cool the
conditioner. This not only improves cooling
efficiency, but also saves energy.
When in Cool or Fan modr there is no need for water
drainage.
During dehumidifying mode, when water in the water
tray exeeds the alarm level, the unit will alarm
automatically and the full water indicator illuminates.
In this case, you have to drain the condensate in the
unit; щtherwise, you hear a beep five times, after
which the unit will automatically turn off.
Manual drain
1.
Ones the unit shuts down upon full water, turn off the
power of ttio unit and than unplug the power plug.
Note:
move the unit carefully to avoid spillage of water
in the water tray at the bottom of the unit.
2.
Put the vessel that holds water below the water outlet
at the back of the unit.
3.
Screw off the drain cap, unplug the water plug and
water will flow into the vessel that holds
water
automatically.
Note:
1. Protect the drain cap and water plug property.
2. Turn the unit slightly backward when draining.
3. If the vessel that holds water can nor hold all water
in the unit before the vessel that holds water it full
of water, block the water outlet with the water plug
possible to prevent the water from flowing onto the
around or carpet.
4. Once the water is fully drained, insert the water
plug and acraw on the water cap tightly.
Note
: 1. Turn on the unit only after the water plug and
drain cap are installed property; otherwise, the
condensate of the unit will flow onto the ground or
carpet.
Note:
frequent condensate tray full alarm may be a
problem.
Contact the service center for advise/ help/service.
Alternatively, in extreme humidity in tropical zones,
the unit may not be able to evaporate the condensing
water effectively, in this instance, follow the same
procedure for dehumidifying mode.
