14
AUTOTUNE 1 TROUBLESHOOTING
FLOW DIAGRAM
SW-MB005 – MAINTENANCE INSPECTION ON S1, S2 AND S3 CARRIAGE ROLLERS / FEBRUARY, 2016
Y
Y
N
N
Y
Y
N
Y
N
Y
N
Y
N
Y
N
Y
N
Y
N
Y
N
Y
N
PROBLEM
FIXED?
CONFIRM TANK IS
PRESSURIZED USING
PRESSURE GUAGE
TANK
PRESSURIZED?
CONTACT SHOCKWAVE
SUPPORT CODE #1
(TANK NOT PRESSURIZING)
JUMP TERMINALS OF
PRESSURE SWITCH TO
TEST COMPRESSOR
DOES
COMPRESSOR
RUN?
CHECK SYSTEM FOR LEAKS
AND LOOSE HOSES
PROBLEM
FIXED?
CHECK CONNECTIONS AND
CONFIRM 12VDC AT
COMPRESSOR RELAY
CONNECTIONS
OK?
CONTACT SHOCKWAVE
SUPPORT CODE#3
(COMPRESSOR)
REPAIR AS
REQUIRED
FINISH
TOGGLE / PUSH SWITCH
TO ‘DRAIN’
START
DOES ICE CONSOLE
LIFT UNTIL AT FULL
HEIGHT?
TOGGLE SWITCH TO ‘SET’
DOES ICE
DROP TO
SAG HEIGHT?
TOGGLE SWITCH
TO ‘FILL’
CHECK CONNECTIONS AND
12VDC AT SWITCH #2
PROBLEM
FIXED?
CONFIRM OPERATION OF
SOLENOIDS #5-8 AND
CONNECTIONS TO GROUND
DOES ICE
CONSOLE LOWER
TO THE GROUND?
CONFIRM OPERATION OF
SOLENOID #9 AND
CONNECTIONS TO GROUND
CHECK CONNECTIONS
AND 12VDC AT SWITCH #3
PROBLEM
FIXED?
NOTE: ALWAYS CONFIRM POWER
SOURCE IS SWITCHED ON AND
FUNCTIONING CORRECTLY
PROBLEM
FIXED?
PROBLEM
FIXED?
CONTACT SHOCKWAVE
SUPPORT CODE#4
(SOLENOID)
CONTACT SHOCKWAVE
SUPPORT CODE#2 (POSSIBLE LEAK)
CONFIRM OPERATION OF
SOLENOIDS #1-4, 10 AND
CONNECTIONS TO GROUND
See Electrical Diagram on page page 13 for reference.
AUTOTUNE 1 TROUBLESHOOTING FLOW DIAGRAM
