MGP34 Operator Manual
Supreme Bench Sander
9
To replace the belt:
1.
Take off the bayoneted sanding wheel from the motor shaft.
2.
Unscrew the nut at the end of the rubber wheel to release
pressure. You do not need to take it off. Only unscrew the nut.
3.
Slide the sanding belt out of the rubber wheel.
4.
Remove the sanding belt and replace with the new one.
5.
Tighten the nut with enough pressure to avoid the sliding of the
sanding belt.
6.
Install the bayonet on the motor shaft.
WARNING:
Do not start Sander before checking for proper
installation of the bayonet on the motor shaft.
Never leave machine running while unattended. Turn it
off.
