MGP34 Operator Manual
Supreme Bench Sander
13
MONTHLY MAINTENANCE
1.
Take off the hose from the blower housing and look at the fan to see if
there are small particles stuck to the fan.
N.B.
Those small particles can create vibrations of the bench sander.
2.
Clean your dust bag with a shop vac or a vacuum cleaner.
N.B.
You should change your dust bag at least every 2 years to increase the
efficiency of the dust collector.
LUBRICATION
Your Supreme Sander is equipped with sealed bearings throughout, which
should be replaced if they ever wear out.
Other parts should not require any lubrication, only cleaning the parts is required.
Lubrication will only attract dust and would be more harmful than helpful.
MOTOR REPLACEMENT
WARNING:
Motor replacement requires working with electrical
wiring and can be hazardous. If you are not familiar with
electrical procedures, please call a qualified electrician.
To remove the motor, these procedures should be followed:
1.
Disconnect the electrical power supply.
2.
Take off the back panel to have access to the motor.
3.
From the bottom of the machine, remove the four (4) bolts holding the
motor.
4.
Disconnect the wiring from the switch and from the electric cord.
5.
Mark the electrical wires to the motor such that you will be ABSOLUTELY
CERTAIN where to reconnect them on the new motor.
6.
Reassemble with new motor in reverse order to the above procedures.
