MGP34 Operator Manual
Supreme Bench Sander
5
•
This grinder is equipped with an approved 3-conductor cord rated at 300V
and a 3-prong, grounding type plug (
See Figure 1
) for your protection
against shock hazards.
•
Grounding plug should be plugged directly into a properly installed and
grounded 3-prong grounding-type receptacle
(See Figure 1
).
•
Do not remove or alter grounding prong in any manner. In the event of a
malfunction or breakdown, grounding provides a path of least resistance
for electrical shock.
WARNING:
Do not permit fingers to touch the terminals of plug
when installing or removing from outlet.
•
Plug must be plugged into matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances. Do not
modify plug provided. If it will not fit in outlet, have proper outlet installed
by a qualified electrician.
•
Inspect tool cords periodically, and, if damaged, have repaired by an
authorized service facility.
•
Green (or green and yellow) conductor in cord is the grounding wire. If
repair or replacement of the electric cord or plug is necessary, do not
connect the green (or green and yellow) wire to a live terminal.
•
Where a 2-prong wall receptacle is encountered, it must be replaced with
a properly grounded 3-prong receptacle installed in accordance with
National Electric Code and local codes and ordinances.
WARNING:
This work should be performed by a qualified electrician.
Figure 1. 3-Prong Receptacle
