OTHER MOTORS
To remove the motor, these procedures should be followed:
1.
Disconnect the electrical power supply.
2.
From the rear of the machine, remove the four (4) screws, nuts, and washers holding
the motor. Remove V-belt.
3.
Disconnect the electrical wiring by removing the electrical plate on the end of the
motor. Mark the electrical plate on the end of the motor. Mark the electrical wires
to the motor such that you will be ABSOLUTELY CERTAIN where to reconnect
them on the new motor.
4.
Reassemble with new motor in reverse order to the above procedures.
NAUMKEG MOTOR
To remove the Naumkeag motor, these procedures should be followed:
1.
Disconnect the electrical power supply.
2.
Remove four (4) screws, nuts and washers that hold motor to swivel plate. Remove
motor.
3.
Loosen set screw on Naumkeag shaft and remove shaft.
4.
Reassemble with new motor in reverse order to above procedures.
17
