S400 S600 Operator Manual 2009
Supreme Sander
13
DUST EXTRACTOR MOTOR
The dust extractor motor can be easily removed from the back of the machine.
To remove the motor, these directions should be followed.
1.
Disconnect the electrical power supply.
2.
Remove motor electrical box plate and observe the electrical wires
connected.
3.
Mark the electrical wires to the motor such that you will be ABSOLUTELY
CERTAIN where to reconnect them to the new motor.
4.
Disconnect the electrical wires and the connector on the motor box.
5.
Remove the eight (8) nuts and washers holding the fan housing plate to
the machine.
6.
Remove entire assembly of fan housing and motor plate from the
machine.
7.
Loosen the two (2) screws on the fan.
8.
Pull the blower wheel off of the shaft.
9.
Remove the four (4) screws that hold the motor to the fan housing.
10.
Reassemble with new motor in reverse order of above.
11. Reconnect
the
power
supply.
12.
Turn the blower motor on and place your hand near a dust extraction port
to see whether the blower is not running backwards.
If you do not already know how to fix this without referring to this manual,
call a qualified electrician.
WARNING:
Be absolutely certain to reconnect the electrical wire to
the proper terminals.
Failure to do so can result in improper motor rotation, a
ruined motor, fire, or injury to yourself.
