-3-
D3038 Remote Dust Collector Switch
Figure 6
. Battery installation/
replacement.
Figure 5
.
ON
/
OFF
Switch location.
ON/OFF Switch
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Unit will not turn on.
1. Remote is out of range.
2. Signal is obstructed.
3. Remote is not turned
ON
.
4. Dust collector is turned
OFF
5. Receiver circuit breaker has
tripped.
6. Wall circuit breaker has tripped.
7. Remote battery is weak/dead.
8. Connected to a machine with a
magnetic switch.
9. Dust collector is at fault.
10. Remote control transmitter is at
fault.
11. Receiver unit is at fault.
1. Move remote closer to receiver unit.
2. Remove obstructions to provide direct line of sight
between remote and receiver.
3. Turn
ON
remote control transmitter.
4. Turn
ON
dust collector.
5. Allow unit to cool, then press the button on the
bottom of the receiver unit to reset breaker.
6. Reset wall circuit breaker. Check that breaker is in
good condition and circuit is properly sized for the
dust collector in use.
7. Replace weak/dead battery.
8. Only use this unit on machines with standard
ON
/
OFF
toggle switches.
9. Refer to dust collector manufacturer's
documentation for troubleshooting.
10. Check/use second remote.
11. Replace unit.
Troubleshooting
Replacing Batteries
1.
Remove the two screws from the back of the remote
control transmitter.
2.
Remove the back of the remote control transmitter,
as shown in
Figure 6
.
3.
Remove the existing battery, then install a new 9V
battery.
4.
Replace the back of the remote transmitter and
secure it with the two screws removed in
Step 1
.
6.
Turn the remote control transmitters
ON
with
the
ON
/
OFF
switch shown in
Figure 5
. The LED
indicators will light to show the transmitters are
working.
— If the LEDs don't light, remove the protective
covering from the batteries. See
Replacing
Batteries
below to access the batteries.
Note:
To conserve battery life in the remote control
transmitters, only turn them on when they are
needed for use.
7.
Turn the switch on the dust collector unit to the
ON position. Test the function of the remote dust
collector switch by pressing the
ON
and
OFF
buttons
on each remote.
Tip:
During long-term storage, remove the batteries from
the remote control transmitters to prevent damage from
battery leakage or corrosion.
