1
3
2
4
6
7
5
REF PART #
DESCRIPTION
1
XD4934001
HELICAL CUTTERHEAD 13"
2
XD4934002
CARBIDE INSERT 15 X 15 X 2.5MM (10PK)
3
XD4934003
FLAT HD TORX SCR T-25 #10-32 X 1/2
4
XD4934004
BALL BEARING 6204-2NSE
5
XD4934005
T-HANDLE TORX DRIVER T-25
6
XD4934006
HELICAL PINION GEAR 8T
7
XD4934007
BALL BEARING 6202-2NSE
Figure
25
.
Rotating indexable carbide insert.
Reference Dot
-8-
D4934 13" Helical Cutterhead Instructions
Item(s) Needed:
Pair of Heavy Leather Gloves ......................1
T-Handle Torx Driver T-25 ..........................1
T-30 Torx Driver (Included w/DW735/X) .........1
Carbide Inserts 15 x 15 x 2.5mm ...... As Needed
Light Machine Oil ........................ As Needed
Clean Shop Rags .......................... As Needed
The Model D4934 13" Helical Cutterhead is
equipped with 30 indexable carbide inserts.
Each insert can be rotated to reveal any one
of its four cutting edges. If one cutting edge
becomes dull or damaged, rotate it 90˚ to reveal
a fresh cutting edge, as shown in
Figure
25.
Rotating/Replacing Indexable Inserts
IMPORTANT: Proper cleaning is critical to
achieving a smooth finish. Contaminants
trapped between the insert and cutterhead
will slightly raise the insert, making
noticeable marks on your workpieces the
next time you plane.
6. Lubricate Torx screw threads with a light
machine oil, wipe excess oil off threads,
and torque screw to
48-50 inch/pounds.
7. Return planer to its original configuration
by performing
Steps 33–38 of Installing
Helical Cutterhead instructions.
Accessories
D4297—Indexable Carbide Inserts (10 pack)
Replacement indexable carbide inserts for Model
D4934 13" Helical Cutterhead.
Parts Breakdown & List
Each insert has a reference dot on one corner.
As the insert is rotated, the reference dot
location can be used as an indicator of which
edges are used and which are new. When the
reference dot revolves back to its starting
position, the insert should be replaced.
To rotate or replace an insert, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Cover table under cutterhead carriage with
scrap cardboard to protect surface from
dropped parts/tools.
3. Gain access to cutterhead by performing
Steps 2–6 of Removing Existing
Cutterhead instructions.
4. Remove Torx screw and carbide insert.
5. Clean all dust and dirt off insert and
cutterhead pocket from which insert was
removed, and replace insert so a fresh,
sharp edge is facing outward.
