INTRODUCTION
The
SHOP FOX
®
Spray Gun features a 1.5mm nozzle
and 750cc paint canister that offers consistent spray
patterns and fast coverage.
SETUP
The Model D3276 accepts
1
⁄
4
" NPT connectors. Mount an
air regulator as close as possible to the spray gun.
Use the adjustment knob on the regulator to set
your working air pressure between 65-85 PSI.
ADJUSTMENTS
See
Figure 1
to identify the location of the spray
gun controls and adjust in the following order:
1.
Nozzle Control
—
Adjusts the spray pattern
from vertical to horizontal.
2.
Pattern Control
—
Variably adjusts the spray
pattern from round to a wide fan.
3.
Fluid Control
—
Adjusts how far back the
trigger can be pulled, which affects the
volume of paint released.
OPERATIONS
Hold the sprayer 8"–10" from the workpiece, and
keep the spray gun perpendicular to the workpiece
during strokes.
DO NOT pivot your wrist when
spraying!
MAINTENANCE
1.
Clean the spray gun by flushing it with thinner.
DO NOT immerse the gun in the thinner!
2.
To avoid internal damage, clean the air cap
with the supplied brush.
Instruction Sheet
Model D3276
Spray Gun
COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
SEPTEMBER 2003, PRINTED IN CHINA.
Figure 1.
Model D3276.
Fluid
Control
Pattern
Control
Nozzle
Control
EXPLOSION HAZARD! Do not
spray flammable fluids near
an open flame or ignition
source.
CUSTOMER SERVICE
For questions contact Woodstock International
Technical Support at (360) 734-3482, or send e-
mail to: tech-support@shopfox.biz.
EYE INJURY AND
RESPIRATORY HAZARD!
Always use safety glasses
and respirator rated for
paint and solvent vapors
while using sprayer.
