-13-
The control panel allows you to control the
sander electronically. For shipping, the control
box comes bolted to the sander with L-brackets.
Retain these brackets should you ever need to
ship the sander. See
Figure 13
.
To install the control box, do these steps:
1.
Remove the L-brackets, bolts, and washers
securing the control box to the back of the
sander. See
Figure 14
.
2.
Position the control box on the sander and
secure with (2) 3/8" flat washers and (2)
3/8"-16 X 2" hex bolts.
3.
Tighten the bolts. See
Figure 14
.
Control Box
The crank and handle is used to raise and lower
the conveyor. For each revolution of the crank,
the conveyor moves 0.021".
To install the crank and handle, do these steps:
1.
Thread the handle into the crank and use a
1
⁄
2
" wrench to tighten the handle to the crank.
2.
Slide the handwheel onto the shaft and
align the threaded set screw bore on the
crank with the flat on the shaft.
3.
Thread the
5
⁄
16
"-18 x
1
⁄
2
" set
screw into the
crank to secure the handwheel to the shaft.
See
Figure 15
.
4.
Use the 4 mm hex wrench and tighten the set
screw.
Crank and Handle
ASSEMBLY
Figure 14.
Installing new hex bolts and
washers.
Hex
Bolts
Figure 13.
The control box, L-brackets, and
bolts for shipping.
Shipping
Bolts
L-Bracket
Figure 15.
The crank and handle installed.
Handle
Set Screw
Summary of Contents for SHOP FOX W1678
Page 48: ...NOTES...
Page 49: ......
