-12-
W1754 20" Planer With Mobile Base
SE
T
U
P
To attach the table extension wings, do these steps:
1.
Install the M8-1.25 x 20 set screws in the holes in
the bottom of the wings (
Figure 5
).
2.
With the help of an assistant, attach the table
extension wings to the planer table (
Figure 5
) with
the M8-1.25 x 35 hex bolts. Finger tighten the bolts
for now.
3.
Check table-to-extension wing alignment (
Figure
6
) with a straightedge and adjust the leveling set
screws until the table and wings are flush.
4.
Tighten the hex bolts.
Figure 5
. Extension wing fasteners and
leveling controls.
Figure 6
. Example of leveling extension
wings and table.
Extension Wings
Extension wings are heavy and could cause per-
sonal injury if dropped during installation. Have an
assistant hold the table while you fasten it to the
planer.
Set Screws
Hex Bolts
Summary of Contents for W1754H
