-27-
Model W1843 (For Machines Mfd. Since 3/17)
O
PE
R
ATIO
NS
The sanding arm assembly tilts to a horizontal position, as
shown in
Figure
27
. This arrangement is more convenient
for certain types of sanding or grinding operations.
To position the sanding arm assembly horizontally, do
these steps:
1. DISCONNECT MACHINE FROM POWER!
2. While holding the arm assembly, loosen the two
set screws in the round end of the pivot arm
(see
Figure
26
).
3. Pivot the assembly to the desired angle, then
re-tighten the pivot arm set screws to secure it in
place.
Figure
26
. Pivot arm set screw locations.
x 2
4. Adjust the tool rest in the position (see Figure
27
)
that is correct for your operation.
Note: If you will be using the contour of the drive
wheel for sanding or grinding, remove the tool
rest assembly so that it will not interfere with the
operation. Otherwise, you will need to mount it
differently so that it will not interfere with the
sanding belt.
5. Check and adjust, if necessary, the sanding belt
tracking (refer to
Adjusting Sanding Belt Tracking
on
Page 25 for detailed instructions).
Figure
27
. Sanding arm assembly in the
horizontal position.
Tool Rest
Tools.Needed.
Qty
Hex Wrench 5mm ...............................................1
Hex Wrench 6mm ...............................................1
