-18-
Model W1854 (For Machines Mfd. Since 02/18)
SE
TU
P
Recommended.CFM.at.Dust.Port:................. 400.CFM
Dust.Collection
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection “how-to” book.
You may attach the Model W1854 drum sander to a dust-
collection system if you do not use the included dust
bag. If you are using your own dust-collection system, we
recommend using a system that can collect a minimum of
400 CFM
AT.THE.DUST.PORT
.
When the dust collection is working properly, a fine layer
of dust may be present on your stock as it comes out of
the sander. This is a normal characteristic of all drum
sanders.
Items.Needed.
Qty
Dust-Collection System ........................................1
Dust Hose 4" .....................................................1
Hose Clamps 4" ..................................................2
To.connect.dust.port.to.a.dust.collector,.do.these.
steps:
1. Fit 4" dust-collection hose to dust port and secure in
place with hose clamp (see
Figure
13
).
2.
Tug hose to make sure it does not come off.
Note:
A tight fit is necessary for proper
performance.
This. machine. creates. substantial.
amounts. of. dust. during. operation..
Breathing. airborne. dust. on. a. regular.
basis. can. result. in. permanent.
respiratory.illness..Reduce.your.risk.by.
wearing.a.respirator.and.capturing.the.
dust.with.a.dust-collection.system.
Figure.13.
Dust port connected to dust-
collection system.
4" Dust
Hose
Hose
Clamp
Summary of Contents for W1854
Page 53: ...Model W1854 For Machines Mfd Since 02 18 ...
Page 56: ......