-30-
Model W1854 (For Machines Mfd. Since 02/18)
M
A
INTE
N
A
N
CE
Figure
27
. Helical gear location.
Figure
26
. Table lift screws (2 of 4).
Table.Lift.Screws,.Chain,.&.Helical.Gears
Oil Type .................................. NLGI#2 or Equivalent
Oil Amount ........................................... As Needed
Check/Add Frequency ................................ 6 Months
DISCONNECT MACHINE FROM POWER SUPPLY!
Lubricate the table lift screws, chain, and helical gear
with lithium grease every 6 months. Clean the chain
and table lift screws (see
Figure.26
), then apply grease
onto the chain links and screw threads. Clean the helical
gear (see
Figure.27
) and place a dab of grease on the
teeth. Move the table up and down to spread the grease
thoroughly throughout the mechanism.
Lubrication
The feed belt bushings should be lubricated daily with ISO
32 Multi-Function Machine Oil. The bearings do not need
lubrication.
Avoid using excess lubrication. Too much lubricant
attracts sawdust and will clog the belt bushings.
Bushings
Oil Type ..................................... ISO 32 Machine Oil
Oil Amount ........................................... As Needed
Check/Add Frequency ..................................... Daily
Oil the drive bushings on each end of the conveyor belt
rollers (see
Figure.25
). Wipe off excess oil.
Figure.25.
Conveyor belt bushing locations
(drive-motor end).
Summary of Contents for W1854
Page 53: ...Model W1854 For Machines Mfd Since 02 18 ...
Page 56: ......