-32-
Model W1854 (For Machines Mfd. Since 02/18)
M
A
INTE
N
A
N
CE
SERVICE
General
A worn/damaged V-belt will not provide optimum power
transmission from the motor to the drum belt. Inspect the
V-belt closely; if you notice fraying, cracking, glazing, or
any other damage, replace the belts.
V-belt removal and replacement is simply a matter of
loosening the V-belt, rolling it off of the pulleys, replacing
it with a new belt, then re-tensioning pulleys.
Items.Needed.
Qty
Hex Wrenches 4, 8mm ....................................1 Ea.
Phillips Head Screwdriver #2 ..................................1
V-Belt (Part X1854069) .........................................1
Straightedge .....................................................1
To.replace.V-belt,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Remove pulley belt access cover.
3. Loosen motor mount cap screws shown in Figure
29
.
4. Lift motor pulley to de-tension belt, and tighten
motor mount cap screws (see
Figure
29
) to keep
motor de-tensioned during belt change.
5..
Roll V-belt off both pulleys and install new V-belt
on pulley grooves for desired speed setting (see
Changing Sanding Drum Speeds on Page 27).
6.
Properly tension V-belt (refer to
Tensioning V-Belt
on
Page 33 for more information).
7.
Re-install
pulley belt access cover from
Step 2.
Replacing.V-Belt
MAKE. SURE. that. your. machine. is.
unplugged. during. all. service. proce-
dures!. If. this. warning. is. ignored,. seri-
ous.personal.injury.may.occur.
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
techsupport@woodstockint.com.
New. V-belts. will. often. stretch. and.
loosen.after.approximately.16.hours.of.
use..Check.frequently.after.installation.
and.re-tension.if.necessary..
Figure.29..
V-belt replacement
adjustments.
Motor Mount Cap Screws
V-Belt
Motor
Pulley
Sanding
Drum
Pulley
Summary of Contents for W1854
Page 53: ...Model W1854 For Machines Mfd Since 02 18 ...
Page 56: ......