-37-
Model W1854 (For Machines Mfd. Since 02/18)
SE
RV
IC
E
Replacing the conveyor belt is a relatively simple process,
but it will require re-tensioning and tracking once the new
conveyor belt is installed.
Items.Needed.
Qty
Open-End Wrench 12mm.......................................2
Hex Wrench 6mm ...............................................1
Permanent Marker (or other, see
Step 2) ...................1
An Assistant ......................................................1
To.replace.conveyor.belt,.do.these.steps:
1.
DISCONNECT MACHINE FROM POWER!
2..
Use a permanent marker, paper correction fluid, or
fingernail polish to mark front of each conveyor belt
tensioning bolt (see
Figure.36
) on both sides. This
step will aid you in returning bolts to their original
position, reducing amount of tracking necessary.
3.
Loosen lock nuts shown in
Figure.36
. Turn both
conveyor belt tensioning bolts counterclockwise one
full turn at a time to release tension from conveyor
belt.
4.
Remove outside table cap screws shown in
Figure.37
and loosen corresponding cap screws on inside edge.
5.
Have assistant lift outside edge of table, then slide
conveyor belt off.
6..
Clean any dirt or dust off table and rollers, have
assistant lift table, then slide new conveyor belt on.
7.
Re-install and tighten all table cap screws.
8.
Tighten conveyor belt adjustment bolts equally, then
follow tensioning instructions on
.Page.36
.
.
Note:
The conveyor belt will stretch slightly when
new and will need to be re-tensioned after a short
amount of use.
9.
Track new conveyor belt according to instructions on
Page 35.
.
Note:
One side of the conveyor belt may need to be
tighter than the other for the belt to track straight.
Replacing.Conveyor.Belt
Figure
37
. Conveyor belt table outside cap
screws.
Table Cap Screws
(Outside, 2 of 4)
Figure
36
. Conveyor belt tensioning
controls (outside of table shown).
Lock
Nut
Conveyor Belt
Tensioning Bolt
Conveyor
Belt
Summary of Contents for W1854
Page 53: ...Model W1854 For Machines Mfd Since 02 18 ...
Page 56: ......