-38-
Model W1854 (For Machines Mfd. Since 02/18)
SE
RV
IC
E
The gauge blocks described here will be required to
complete the remaining service procedures in this section.
Items.Needed.
Qty
6' Long 2x4 .......................................................1
Miter Saw (or Circular Saw) ...................................1
Jointer ............................................................1
Table Saw ........................................................1
To.make.gauge.blocks,.do.these.steps:
1.
Edge joint concave edge of 2x4 flat on a jointer, as
shown in
Figure.38
.
Making.Gauge.Blocks
Figure.38..
Edge jointing on a jointer.
15
30
45
Previously
Jointed
Edge
Opposite Edge
Rip Cut with
Table Saw
Figure.39..
Rip cutting on a table saw.
2.
Place jointed edge of 2x4 against table saw fence
and rip cut just enough off opposite side to square
up two edges of the 2x4, as shown in
Figure.39
.
3.
Cut 2x4 into two even pieces to make two 36" long
wood gauge blocks.
Note:
Steps 1-2
can be skipped, but having the
gauge blocks at an equal height is critical to the
accuracy of your adjustments.
Summary of Contents for W1854
Page 53: ...Model W1854 For Machines Mfd Since 02 18 ...
Page 56: ......