Page
of 6
4
ASSEMBLY
1. Please refer to Figure 1, and pull out the pin shaft 23.
Figure 1
Figure 2
2. Insert Handle Tube into Position A. Connect Handle tube and the pump body 31 via the pin
shaft 23.
3. Replace pin shaft #23, and put the spring pin 24 through pin shaft 23 to secure.
4. Please refer to Figure 2.
Insert the chain #10 of the Handle Tube through the hole of the
pin shaft 23.
Figure 3
Figure 4
5.
Put the screw and nut at the end of chain 10 into the slot of the lever plate. Please refer to
Figure 2 and Figure 4.
6.
Refer to Figure 3, move the handle to a horizontal position, pull out pin B and store to be
used for Handle replacement in the future. The pallet truck assembly is complete.
Check before using
1. After the assembly is complete, move the Trigger (# 1, Figure 5, below) into the three
different positions. This assures pallet operates lowering, neutral and raising operations
correctly after assembling.
2. The Screw #54 in Fig. 4 is used for the adjustment of the truck. When the truck body lowers
shortly after rising, turn Screw 54 a little counterclockwise before trying the truck again. In
the case that the truck body is unable to lower, turn Screw 54 a little clockwise and then try
the truck again till the truck is able to lower normally. The Hex nut 53 functions as a lock, so
it needs to be loosened before adjustment is made and locked after modification.
Figure 5
