15
Position rip fence (B) over the table as shown in Fig. 11. Lower
the rear end of the rip fence (B) over the back of the table;
then lower the front end (with lock handle ) over the front of
rail on the front of the saw. Engage lock on the rip fence after
placing fence in desired location on the table (Fig. 11).
Do not use rip fence and miter gauge at
the same time without using a cut off block
(gauge) as described in the Cutting Aids and Accessories
section of this manual.
ASSEMBLY
RIP FENCE
TIGHTEN
LOOSEN
Figure 12
Figure 11
Check to ensure that the rip fence is secured to the table prior
to use when making a cut. If needed adjustments to tighten or
loosen rip fence can be made by adjusting the lock nut on the
rear side of the fence (Fig. 12).
For thin materials use the fence on the left of the blade. Fold
down the thin fence to allow use of blade guard. Subtract 2
inches from the scale for accurate measurement (Fig. 11 B).
B
A
B
