Shoprider Sena 888WNLS, User Manual

Continued….. 

Seat Height 

(We recommend that this operation be carried out by two persons) 

The seat can be set at three different heights. 

Release Levers 

Firstly, ensure that the power is switched off and 
carefully unplug the joystick at the rear of the 
powerchair. Stand at the front of the powerchair 
and hold the seat while the second person 
releases the two yellow levers on the underside 
rear of the seat. Pivot the rear of the seat up to the 
front of the chair. Hold the chair in this position 
taking care not to let the seat rest on the joystick. 
Remove the locking pins to raise or lower the two 
rear seat support brackets to the required height and refit 
the pins. Replace the seat. To adjust the front seat height 
remove the locking pin from the left hand support bracket. Support the seat 
and gently pull out the right side spring locking pin and adjust to the required 
height. Ensure the locking pins are fully re-engaged before operating the 
powerchair. 
 

Backrest angle 

Pull up on the backrest reclining lever (left hand side of 
the seat) and set the angle required by holding

 the 

backrest in the desired position and then release the 
lever, the backrest will stay in the position selected. 
The backrest can be lowered forward onto the seat for 
storage or transport. The backrest is spring-loaded and 
should be restrained from going forward when the lever 
is released. 
 

Note: The powerchair will become more unstable the further the 
backrest is reclined. Do not attempt to climb kerbs or slopes with the 
backrest in any reclined position. Do not carry bags on the back of the 
seat as they may affect stability. 

Rear View 

6