Shoprider UL8W36, User Manual

3/13/2008 

19

Battery Charging Procedure 

 
There are two ways to charge the Trooper Powerchair

          
         Battery on chair charging method  

1) Plug the A/C power cord into the wall. Plug the male three-pin 

charger plug into the female 3-pin receiver located on the 
bottom of the VSI (Refer to Figure 3, #8). 

Battery off chair charging method 

2) Remove the battery-pack from the unit. Plug the A/C power 

cord into the wall. Located on the battery-pack is a charger port. 
Slide the charger port cover over to expose the charger female 
3-pin receiver. Plug the male three-pin charger plug into the 
female 3-pin receiver. It is not necessary for the battery-pack to 
be attached to the Powerchair to charge. 

 
The battery charger’s light indicator is as follows: 
One light charger (4Amp) 
Yellow/Amber    - Charging 
Green - 

Charging complete 

 
NOTE: It is very important to check the charger light color. IF there is 
no light or a different color light on than should be, refer to the 
charging troubleshooting section in this manual. amount of battery 
Depending on the amount of battery discharge, the charge can take 
up to 12 hours. The battery charger has an electronic switch that will 
terminate the charge when the batteries are fully charged.  Do not 
remove the battery charger until the charging cycle is complete. Be 
sure to unplug the charger from the wall first before unplugging 
charger from the Powerchair. 
 

WARNING! Only use the original manufacturer approved 
charger! 
This charger is for indoor use only. Do not expose it to rain or 
water spray. 
Do not leave the charger plugged into the Charging Port if the 
charger is not charging.