PowerPro – LIFT ASSIST
556191
3
INSTALLATION
Your PowerPro Lift Assist comes disassem-
bled and must be mounted to your MARK
correctly to ensure proper operation.
1.
First, remove the Worktable from the
Carriage and slide the Headstock to
within about 12" of the left side (top) of
the machine. Slide the Carriage to the left
until it touches the Headstock and tighten
the Headstock & Carriage Locks securely.
2.
Stand the MARK up into vertical (Drill
Press) position and tighten the Arm Lock
Knob.
Mounting Lower Assembly to
the Bench Tubes
3.
Begin laying a Cap (2) across the top of
each Bench (lower) Tube, at the Base &
Base Arm (right) end of the MARK. (See
Figure 2) They should be positioned all
the way to the right, solidly against the
Base.
Lay the Lower Tie (4) across the tops of
the two Caps...with its vertical surface
projecting upwards, and against the
MARK Base. See Figure 1 for proper
orientation.
4.
Drop four 3-1/4" LONG Bolts (8) down
through the Lower Tie & Cap holes that
mount to the back Bench (lower) Tube.
5.
Install a Cap (2), followed by the Lower
Mount (5) over the bolts protruding un-
der the back Bench Tube...so the threaded
hole for mounting the Threaded Ball Stud
(6) is facing towards the front of the
MARK, as shown in Figure 1.
Install four 1/4" Split Washers and
1/4"-20 Hex Nuts over the Bolts and
finger tighten.
6.
Drop four 2-3/4" SHORT Bolts (7) down
through the Lower Tie & Cap holes that
mount to the front Bench Tube. Install a
Cap (2) followed by four 1/4" Split Wash-
ers and 1/4"-20 Hex Nuts over the Bolts
and finger tighten.
7.
Install a Threaded Ball Stud (6) onto the
Arm of the Lower Mount, as shown in
Figure 3 and tighten with a wrench. See
Figure 1 for proper orientation.
Figure 2
Figure 3
