ADM-880C 07/20/09
10
xx
8
n.nnnn
This display indicates that the meter is in TREND mode and that the readings are increasing rapidly. xx indicates
the units for the reading.
xx
`
n.nnnn
This display indicates that the meter is in TREND mode and that the readings are decreasing slowly. xx indicates
the units for the reading.
xx
9
n.nnnn
This display indicates that the meter is in TREND mode and that the readings are decreasing rapidly. xx indicates
the units for the reading.
xx
¸
n.nnnn
Displays the maximum (greatest value) reading for a given measurement mode stored in a specific memory group
during a STORE sequence. Displayed when a particular reading in that measurement mode within that memory
group has been selected using a SCAN key, and the VIEW key is pressed four times. Number of decimal places
will vary.
xx
º
n.nnnn
Displays the minimum (least value) reading for a given measurement mode stored in a specific memory group
during a STORE sequence. Displayed when a particular reading in that measurement mode within that memory
group has been selected using a SCAN key, and the VIEW key is pressed three times. Number of decimal places
will vary.
12-HR s
This prompt indicates that a 12 hour clock is being selected using the meter configuration loop.
24-HR s
This prompt indicates that a 24 hour clock is being selected using the meter configuration loop.
ABS PRES
This signal will be flashed when the absolute pressure measurement mode is selected, and also each time the READ
key is pressed when in the absolute pressure measurement mode. It is also part of the ASSOCIATED READING
sequence and precedes the display of an absolute pressure reading associated with a flow or velocity reading.
ADM-880C
This message is flashed following
$
$
$
$
$
$
$
$
when the meter is first turned on.
AIRFOIL
This signal will be flashed when the AirFoil probe measurement mode is selected and also upon each subsequent
operation of the READ key.
ALT
This message is displayed when the ALT key is pressed.
ASSOCIATED
This message is briefly displayed when ALT / VIEW is pressed while a selected reading in memory is being
displayed. User may toggle through the associated reading displays by pressing the VIEW key repeatedly.
AUTO
This message is displayed as part of the overall meter status if the user presses ALT / READ to display [AUTO
READY], then presses ALT / ALT instead of READ. It indicates that the meter is still ready to initiate an automatic
reading sequence, and will do so if the user presses READ.
AUTO READY
This message indicates that the meter has been placed in the automatic reading function. Press the READ key to
start the automatic reading sequence. Press the READ key to HALT the reading process. [HALT] will be displayed.
AUTO STORE
This message indicates that the meter has been placed in the automatic memory mode, which integrates the
automatic reading function with the sequential storage function, and permits recall of the readings, sum, average and
standard deviation at any point. Press the READ key to initiate the actual reading process. Press the READ key
again to stop the automatic reading sequence. [HALT] will be displayed. Press ALT / AUTO / STORE to resume the
Summary of Contents for AIRDATA ADM-880C
Page 42: ...ADM 880C 07 20 09 37 FIGURE 6 3 VELGRID ASSEMBLY...
Page 50: ...ADM 880C 07 20 09 45 FIGURE 10 1 FRAME STORAGE FIGURE 10 2 FLOWHOOD IN CASE...
Page 51: ...ADM 880C 07 20 09 46 FIGURE 10 3 FLOWHOOD ASSEMBLY...
Page 53: ...ADM 880C 07 20 09 48 FIGURE 10 7 1X5 FRAME ASSEMBLY FIGURE 10 8 3X3 FRAME ASSEMBLY...
