ADM-880C 07/20/09
19
KEY
PRIMARY FUNCTION (F)
SECONDARY FUNCTION (ALT / F)
TERTIARY FUNCTION (ALT / F / ALT / F)
ALT
Alternate
Escape
MODE
MEASUREMENT
TIMED READ
CONFIGURE
Differential pressure
Interval Time
Units - English or Metric
Temperature
Begin Time
Density - Local or Standard
VelGrid velocity
End Time
Time
AirFoil velocity
Max # of Readings
Date
Pitot tube velocity
Absolute pressure
FlowHood air flow
VIEW
STATISTICS
ASSOCIATED DATA
DOWNLOAD
Average
Mode/Units
Download to printer
Sum
Temperature
Minimum
Absolute pressure
Maximum
Differential pressure
Standard deviation
Time and date
STORE
STORE
CLEAR MEMORY
CHANGE MEMORY
Store All
Select memory group
Store Last
Erase reading in memory
Store Off
Replace reading in memory
ON
If meter off, turn on
Turn meter off
If meter on, turn light on
If light on, turn light off
=
SCAN
Scan memory sequence
Go To
ascending
SCAN
<
Scan memory sequence
Reset display
descending
READ
Read/Select
Automatic Readings
Trend Readings
5.1.3 NUMERICAL ENTRY
Numbers must be entered to set the meter’s clock, to set up the timed reading mode, and as part of a GO TO command
using the
=
SCAN key.
Numbers are always prompted by a cursor below the number, and require as many key presses as their
position
on the
key indicates. Selecting the number four requires four key presses, selecting the number eight also requires four key
presses, and selecting the number nine requires one key press.
After a pause, the meter moves the cursor to the next prompting position (to the right) automatically. The cursor may also
be moved using the
=
SCAN and SCAN
<
keys.
5.1.4 GENERAL USE
Press the ON key to turn the meter on. The meter will display a row of pixel blocks to test the display, and will then display
AUTO ZERO while performing a brief internal calibration test. It will briefly display the current measurement mode, such
as [DIFF PRESS], followed by a display, such as [IN READ], that indicates that the meter is ready to take a reading . In
this example, the IN indicates that the units selected are inches of water column. The small battery cell displays the current
battery status, which may be Full, 2/3, 1/3, or Low, depending on the amount of shading within the battery symbol.
The MODE key may be pressed repeatedly to select one of the following measurement modes: temperature, VelGrid
velocity, AirFoil probe velocity, pitot tube velocity, differential pressure, absolute pressure, or FlowHood air flow. The meter
will briefly display the mode, followed by a two-letter symbol for the units to be used, a battery status symbol, and the word
READ. The meter is ready to take a reading in the manual mode.
Press the READ key to take a reading in the selected mode. The meter will briefly display the measurement mode, followed
by the measurement result. Pressing the READ key again will trigger another measurement, which will clear all
previous data from the display and display the new result. If the reading was taken in a velocity or flow mode, the meter
Summary of Contents for AIRDATA ADM-880C
Page 42: ...ADM 880C 07 20 09 37 FIGURE 6 3 VELGRID ASSEMBLY...
Page 50: ...ADM 880C 07 20 09 45 FIGURE 10 1 FRAME STORAGE FIGURE 10 2 FLOWHOOD IN CASE...
Page 51: ...ADM 880C 07 20 09 46 FIGURE 10 3 FLOWHOOD ASSEMBLY...
Page 53: ...ADM 880C 07 20 09 48 FIGURE 10 7 1X5 FRAME ASSEMBLY FIGURE 10 8 3X3 FRAME ASSEMBLY...
