background image

 

If the device has been exposed to temperature changes due to environmental changes, do not 
switch it on immediately. The arising condensation could damage the device. Leave the device 
switched off until it has reached room temperature. 
 
This device falls under protection-class I. Therefore it is essential that the device be earthed. 
If protection screen,lens or ultraviolet screen in the fixture is apparently damaged or is damaged 
to exceed their own effective degree, such as cracked and gashed, it must be replaced. 
 
The electric connection must carry out by qualified person. 
 
Make sure that the available voltage is not higher than stated at the end of this manual. 
 
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case, 
replacement of the cable must be done by an authorized dealer. 
 
Always disconnect from the mains, when the device is not in use or before cleaning it. Only 
handle the power cord by the plug. Never pull out the plug by tugging the power cord. 
 
During initial start-up some smoke or smell may arise. This is a normal process and does not 
necessarily mean that the device is defective, it should decrease gradually. 
 
Please don't project the beam onto combustible substances. 

 

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced 
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.  
 

 

Please be aware that damages caused by manual modifications to the device are not subject 
to warranty. Keep away from children and non-professionals. 
 

3.2) GENERAL GUIDELINES 

This device is a lighting effect for professional use on stages, in discotheques, theatres, etc., the 
device was designed for indoor use only. 
 
This fixture is only allowed to be operated with the max alternating current which stated in the 
technical specifications in the last page of this manual.   
 
Lighting effects are not designed for permanent operation. Consistent operation breaks may 
ensure that the device will serve you for a long time without defects. 

Summary of Contents for Terbly FS300











Reviews: