Important Safeguards:
1.
Electrical enclosure (control box) should be protected with a non-metal roof or shield.
This not only protects the paint finish but also keeps rubber components (gasket, boots,
antenna, etc.) from drying out.
2.
Warning:
Electric shock or malfunction could occur if power cord or plug is damaged
in any way. Do not work Pro Cutter in rain – or allow cord or plug to lie in water
3.
Always use properly grounded 120VAC electrical outlet.
4.
Do not operate Pro Cutter if control box, or any of its components are damaged in any
way, or after malfunction.
5.
Use Pro Cutter only as intended and described in literature.
6.
Always unplug Pro Cutter when through working each day.
7.
Do not allow flag to run into ends, or damage may occur to electronics, rope, or both.
TROUBLE
SHOOTING
Problem:
Solution:
1. Pro Cutter will not operate
Make sure there is power to
using remote control or manual
machine. Check 4A fuse.
switch.
2. Pro Cutter will operate using
Check battery in remote
manual switch but not remote
control. Be sure antenna &
control.
receptacle aren’t damaged.
3. There’s a “clicking” noise
Fuse is blown.
but Pro Cutter won’t run.
replace fuse (4 amp, 250 v.,
fast blow).
NOTE:
The remote control, worn on the rider’s wrist, has a 9-volt battery in the plastic case
inside the pouch.
The battery must be changed on a regular basis
. The first sign that a battery
may be failing is when the flag starts hesitating or “missing” going one direction. The natural
tendency is to press harder on the switch, twist the cable leading to the switches, or tap the remote
control, all of which may result in damage. Avoid these conditions and
replace battery at first
sign of intermittent operation
. Remote control should always be stored indoors.
NOTE:
The antenna, or protective cap, must be securely fastened to receptacle on top of control
box
at all times
. If the antenna or antenna cap is removed or damaged, water can enter the control
box resulting in severe damage to electronics. Care should be taken during installation to mount
unit in a location protected from livestock.
