P
ERFORMANCE
P
ACKAGE SYSTEM UPGRADE
Your Pro Cutter is now equipped with the all new Performance Package. This full
system upgrade enhances your training experience by giving the rider the ability to make
speed adjustments from horseback using STEPPER technology, and an ultra-high
performance remote control radio package. This new “state of the art” operator interface
provides many advantages over other remote control systems. These include user
programmable functions, instant response, extended range, reduced power consumption,
and a flush mount antenna system.
S
TEPPER
T
ECHNOLOGY
:
Stepper Technology refers to the process of changing speeds from horseback using the
wrist mounted remote control. After setting your base speeds on the
Pro Cutter
CONTROL BOX
, the rider can further adjust speed(s) by pressing the SPEED UP or
SPEED DOWN buttons located top of the
remote control pouch. Each press of either
button will result in a 10% CHANGE in speed;
with a total number of 10 STEPS available.
Cycling power ON/OFF on the
Pro Cutter
CONTROL BOX
will reset the STEPPER
back to a “0” setting.
R
EMOTE CONTROL
:
The remote control includes an easily replaceable 9 volt
alkaline
battery and is ready to
operate once your Pro Cutter is installed.
NOTE: Be sure to check the date stamp
when purchasing new batteries.
As with any electronic device, the remote control
should be stored in a cool, dry location to enhance battery life and prevent corrosion.
Should the remote control become wet, damage may be prevented by immediately
removing the battery and leaving the battery door off in a warm, low humidity location
for several hours. The battery should also be removed during extended storage periods
exceeding 2 to 3 months. Direct replacement remote controls are readily available should
the original unit become lost or damaged.
A power button is located on the right side of the remote control pouch. The power
indicator light does
NOT
illuminate when power is ON. It only illuminates when you
press the directional switches on the remote control
OR
one
of
the Stepper switches.
Battery requires replacement if light is on continuously, or does not illuminate when
control buttons are pressed.
NOTE: ALWAYS turn power button “Off”
on remote control when not in use!
