PAIRING (PROGRAMMING):
At times it is desirable to operate multiple Pro Cutters in close proximity without the
remote controls cross-communicating. This requires a simple PAIRING procedure to
shift the radio package to an alternate frequency. The following procedure outlines the
pairing (programming) process which requires opening the Pro Cutter drive box
with
power applied
. Care must be taken to avoid contact with live circuits or electric shock
may occur. Show Pro Industries accepts no responsibility for damage or injury resulting
from contact with live electrical circuits.
PROGRAM RADIOS AT YOUR OWN
RISK
.
1) Begin by opening the lid on the Pro Cutter drive box. This is accomplished using a
blade screw driver on the ¼ turn lid latch. Once open, the radio receiver is located in
the top-center of the control box (drawing 1). Using drawing 1 as a guide, identify
the black PAIR button located near the center of the receiver circuit board.
(drawing 1)
PAIRING
RF GOOD
BAT/RNGE PAIRING
ANT
RESET
RECEIVER
(HOLE)
PAIRING
BATTERY
RESET
TRANSMITTER
1)
Remove the wireless remote control from the canvas/Velcro pouch. Using drawing 2
as a guide locate the pairing hole in the upper left corner of the remote control case.
A small pin will be required to access the pairing switch.
2)
With power applied to the Pro Cutter drive box, press and release the black PAIR
button on the radio receiver board. A yellow PAIR indicator will illuminate on the
receiver board indicating the receiver is searching for the remote control. Next, press
and release the PAIR button on the remote control using a small pin. You should
now see the yellow PAIR indicator flash and the green RF GOOD indicator
illuminate. Wait for both indicators to turn off before pressing any buttons or
switches.
Pairing is complete once both indicators turn off. Test for proper operation by
pressing the remote control RUN buttons. The green RF GOOD indicator should
illuminate each time a RUN button is pressed. Close Pro Cutter lid being careful to
fully engage lid latch to prevent possible damage from water/dirt entering control
box. Reinstall remote control case into Velcro pouch.
