INSTALLATION INSTRUCTIONS:
Flag Model:
1.
Mount control box: Securely attach control box on one side of
arena. It should be mounted so pulleys on bottom of box are
approximately 45 inches from the ground.
2.
Mount return pulley: Mount off-side return pulley on opposite side
of arena in horizontal position. It should also be mounted
approximately 45 inches from the ground.
3.
Install flat-braid rope: To install flat braid rope, start in center of
arena. Take one end of rope around off-side pulley, across arena,
around pulleys on bottom of control box, and back to center. Tie
one end of rope to left side of flag and other end to right side of
flag while removing slack. Cut extra line.
4.
Apply power: Plug Pro Cutter into grounded 120VAC, 3-prong
outlet. Always unplug unit when not in use. *
EURO MODELS:
240VAC/50Hz
5.
Power on Remote: A power button is located on the right side of
the remote control pouch. Press to turn ON.
Note:
The power indicator light does
NOT
illuminate when power
is ON. It only illuminates when you press the directional switches
on the remote control or the Stepper switches.
(
Refer to Performance Package instructions on page 9
.)
