- 11 -
Filter cloth replacement
(1) Pull out the dust pan, then pull up the
filter cloth clip toward you.
(2) Pull out the filter cloth and lower the
front side of the filter cloth. Remove
filter cloth.
(3) Insert a new filter cloth in the direction
shown in the following photo. Check
that it is inserted into the groove at the
back before pushing it in fully.
(4) Lift up the front side of the filter cloth
and secure it with filter cloth clip. Insert
the dustpan fully.
Shaking rope tension adjustment
If the shaking handle becomes loose or the filter cloth is replaced, adjust the shaking rope tension.
(1) Loosen the two wing nuts for the rope
holder and let the shaking handle come
in contact with the main body.
(Remove the filter cloth.)
(2) While pulling the rope end, rotate the
rope holder in the curved arrow
direction by 2 to 3cm.
(3) Tighten the wing screws of the rope
holder while pulling the rope.
Detail of rope holder
If the rope breaks or is worn severely, replace it with a new one.
Pay attention to
the direction.
Rope
Rope holder
Note: Even after rope tension adjustment, some air
leakage may occur where the rope passes through, but
that will not affect the performance of this machine.
