background image

FCC/IC

ZW1502 2 Outlet Power Strip 

                

Show Home Products warrants this product to be free from manufacturing defects for 

a period of two years from the original date of consumer purchase. This warranty is limited 

to the repair or replacement of this product only and does not extend to consequential or

incidental damage to other products that may be used with this product.

 

This warranty is in lieu of all other warranties, expressed or implied. Some states do not 

allow limitations on how long an implied warranty lasts or permit the exclusion or limitation

 of incidental or consequential damage, so the above limitations may not apply to you. 

This warranty gives you speci

c rights, and you may also have other rights which vary from 

state to state. if the unit should prove defective within the warranty period.

RISK OF FIRE

RISK OF ELECTRICAL SHOCK

RISK OF BURNS

CONTROLLING APPLIANCES:

EXERCISE EXTREME CAUTION WHEN USING Z-Wave

DEVICES TO CONTROL APPLIANCES. OPERATION

OF THE Z-Wave

      DEVICE MAY BE IN A DIFFERENT

ROOM THAN THE CONTROLLED APPLIANCE, ALSO AN

UNINTENTIONAL ACTIVATION MAY OCCUR IF THE WRONG

BUTTON ON THE REMOTE IS PRESSED. Z-Wave 

     DEVICES

MAY AUTOMATICALLY BE POWERED ON DUE TO TIMED

EVENT PROGRAMMING. DEPENDING UPON THE APPLI-

ANCE, THESE UNATTENDED OR UNINTENTIONAL OP-

ERATIONS COULD POSSIBLY RESULT IN A HAZARDOUS

CONDITION. FOR THESE REASONS, WE RECOMMEND

DO NOT RETURN THIS PRODUCT TO THE STORE

THE FOLLOWING:

DO NOT USE Z-Wave 

     DEVICES  TO CONTROL ELECTRIC

HEATERS OR ANY OTHER APPLIANCES WHICH MAY PRES-

ENT A HAZARDOUS CONDITION DUE TO UNATTENDED OR

UNINTENTIONAL OR AUTOMATIC POWER ON CONTROL.

WARNING

WARRANTY

SPECIFICATIONS

Website www.ishowlights.com

Federal Communications Commission (FCC) Statement

FCC Caution: Any changes or modi

cations not expressly approved by the party responsible for 

compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.  This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, 

may caus harmful interference to radio communications.However, there is no guarantee that 

interference will not occur in a particular installation.  If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, 

the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.Increase the separation between the equipment and 

receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.Consult the dealer or an experienced radio/TV technician for help.This equipment 

should be installed and operated with minimum distance 20cm between the radiator and your body.

IC Caution:

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject 

to the following two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired 

operation of the device.

DECLARATION DE CONFORMITE D'INDUSTRIE CANADA

Ce périphérique a été testé et reconnu conforme aux limites spéci

fié

es dans RSS-210. 

Son utilisation est soumise aux deux conditions suivantes :

(1) il ne doit pas provoquer d'interférences gênantes et

(2) il doit tolérer les interférences re.ues, notamment cellessusceptibles d'en perturber le fonctionnement.

Model:ZW1502

Power supply: 110V.

Signal (Frequency): 908.42 MHZ.

Outlet: Two grounded outlets

Cord Length: 3ft.

Wireless Controller and the closest Z-Wave

receiver module.

Speci

cations subject to change without notice

due to continuing product improvement

Reviews: